A treatment system changes what reaches your water heater, but it rarely removes everything. Some sediment, mineral scale and debris from the supply line still settle in the tank, and the heater is the one appliance in the house that quietly holds that material against its heating element or bottom. A yearly check is inexpensive, and it tells you whether the heater is keeping up with the system upstream.
What to look at once a year
Start with what you can see without tools. Look at the base of the tank and the connections for drips, rust streaks or crusty white deposits. Check the cold inlet and hot outlet fittings for seepage. Note whether hot water takes longer to arrive than it used to, or whether the tank makes popping or rumbling sounds while it heats. Those sounds usually mean sediment is sitting on the bottom and trapping heat.
Next, look at the temperature and pressure relief valve and the pipe that runs from it toward a floor drain or the outside. The pipe should be clear and should not drip during normal use. A valve that weeps regularly is a job for a plumber, so do not ignore it or plug the pipe.
Flushing the tank
Many owners drain a few gallons from the valve near the bottom of the tank once or twice a year to see what comes out. Clear water with a faint tint is normal. Grit, flakes or a heavy cloudy load means sediment is building up, and flushing more often may help. Before you open the drain, read the owner's manual for the correct procedure, shut off power or gas as the manual directs, and let the tank cool. If the drain valve is stiff, cracked, or will not close fully after you run it, stop and call a plumber rather than forcing it.
The anode rod question
Many tank-style heaters have a sacrificial anode rod that draws corrosion away from the steel tank. Checking it means shutting off power or gas, draining enough water to reach the rod, and pulling it out, which can be hard in an older tank. Look for a rod that is heavily wasted down to its core wire. If the tank is older and you are not sure the rod can be removed without causing a leak, have a plumber check it during a regular service visit instead of forcing it.
When to hand the job off
Gas burner, flue and venting work, and electrical work belong to a licensed professional. So does any repair involving the relief valve, or a tank that leaks from its body. Call someone if you see water pooling under the unit, if the water temperature swings unpredictably, or if the water still looks discolored after you have flushed. Describe what you saw to the plumber: the sounds, the drain water color, the valve drip, the rod condition, and when you last flushed. That record helps them diagnose the problem faster.
Keep the heater on the same calendar
Put the water heater check on the same calendar as your filter and softener visits, so each year you look at the heater alongside the system upstream. A note that says when you last flushed, what the drain water looked like, and what the valve was doing is worth more than a memory of it a year later.