A pipe that bangs when a faucet or washer shuts off is usually not a mystery. It is pressure energy hitting a closed valve and having nowhere to go. Whether you fix it yourself or call someone depends on where the hammer starts and where an arrestor would have to go.
Confirm it is water hammer first
Note which fixture triggers the noise. A bang at the washing machine when its fill valve closes, or a thump when the dishwasher or ice maker shuts off, points to a fast-closing valve. Run the fixture, shut it off quickly, and listen. If the sound repeats each time and gets louder as flow speeds up, you are dealing with hammer. A loose pipe strap, a rattling joist, or a running toilet can sound similar, so trace the bang to a specific fixture before you buy anything.
What the arrestor does
An arrestor absorbs the shock of a sudden stop. Common designs use a sealed piston or a small air-filled chamber installed near the fixture or valve. Piston types need the right orientation and a rating that suits your line pressure. Air chambers can lose their charge over time and stop working without any obvious sign, which is why a line that was quiet after an install can return to banging later. Read the installation direction and pressure rating on the label, and confirm the fitting size matches your supply line before you buy.
Install it yourself when access is simple
A homeowner with basic tools can often handle an arrestor on an exposed supply line under a sink or behind a washing machine, as long as the shutoff closes fully and the work stays on the supply side. Before you start, close the local shutoff, open a faucet below the work to relieve pressure, and keep a bucket and towels nearby. Install the arrestor in the orientation the label shows. Turn the water back on slowly, then check every joint for seepage after an hour and again the next day.
Hand it off when the job gets bigger
Call a licensed plumber when the arrestor must go inside a wall, when the line is copper that needs cutting and soldering, when the shutoff valves are old and may not hold, or when your local rules require a permit or inspection for changes to supply plumbing. Hire the job too if the hammer comes from the main line or a pressure regulator instead of an appliance. A plumber can measure static and running pressure with a gauge and decide whether the regulator needs attention before any arrestor goes in.
What to ask before you agree
Ask which fixture the arrestor will protect and whether the plumber will test the line after installation, not just check for leaks. Ask whether the fitting will stay accessible for future service, and who is responsible if a new joint seeps. Ask whether the unit is sized to your line and whether you will get the model information for your records. If a quote says only "add arrestor" without naming the location, the fitting, or the test, ask for those details in writing.
Check the result
After any install, run the noisy fixture several times and listen. If a quiet fixture still bangs somewhere else, the hammer has a second source. Set a reminder to recheck joints and listen again after a few weeks of normal use, because a fitting that was tight at install can loosen as pipes settle. For how the ratings treat install scope, see the methodology page.