Some home water treatment units do their work by throwing away water on purpose. A softener sends a rinse to the drain each time it regenerates. A reverse osmosis unit sends a share of the incoming water to the drain as reject flow. Filters that backwash to clean themselves do the same. This water does not appear on the equipment quote, but it can show up on your utility bill or in the load on your septic system. This guide is about that cost, not about where the drain line runs.

Find out which units in your plan drain water

List each piece of equipment in the proposal and note whether it regenerates, backwashes or produces reject water. Ask the provider to state, for each one, roughly how much water goes to the drain per cycle or per gallon treated. If the answer is vague or only in general terms, ask for the figure in writing from the manufacturer's data sheet.

Check what controls how often the drain runs

For a softener, ask whether the regeneration is timer based or demand based, and what setting the installer will use. A timer can regenerate on a schedule whether or not your household used much water. A demand setting runs when the unit has treated a set volume. Ask how the hardness setting and the household size were entered, because those inputs drive how often the cycle fires. For reverse osmosis, ask whether the reject ratio is fixed or adjustable and whether the unit includes a flow restrictor that the installer has sized for your pressure.

Read your own bill

Pull a recent water and sewer bill and look at how sewer or wastewater is charged. In some areas it is billed on the water that enters the home, so drain water from treatment equipment is counted again on the way out. If you run a private septic system, the added drain flow matters for the tank and the drain field, not for a bill. Either way, you cannot judge the cost until you know which of these applies to your home.

Compare on drain water per gallon of usable water

When two proposals are otherwise close, compare the drain water each one produces for the same amount of treated water you use. A unit that looks cheaper on paper can cost more over time if it wastes more water per gallon. Write both figures next to each other and ask each provider to explain the difference in plain terms.