A UV unit is one of the simpler water treatment installs on paper, but the steps are unforgiving. The light only works on water it can reach, the lamp has a rated life that you will be tracking, and a unit that is installed in the wrong place or on the wrong power source can look fine until it stops doing its job. This walk-through follows the order most installs take, so you know what to check at each stage.
Before the install day
Start with the water itself. A UV unit does not remove minerals, chemicals, or sediment, and cloudy water can shield germs from the light. Ask the installer whether the unit needs a sediment pre-filter upstream, what micron rating the manufacturer requires, and who supplies that filter. Get the answer in writing on the quote, because a missing pre-filter is a common source of trouble later.
Next, confirm the flow rating. The unit's spec sheet lists a maximum flow it can treat at the stated dose. Ask the installer to show you where your household's peak flow falls against that number, including the case where a shower and a washer run at the same time. A unit that runs at the top of its rating all day has less margin than the brochure suggests.
Placement and plumbing
Confirm where the unit sits in the line. Most manufacturers want it after the pre-filter and before any point where the water could pick up contamination again, and many want it on the cold line ahead of a water heater. Ask the installer to point to the spot on the plan. Check that the unit is mounted where the lamp can be reached without moving the whole assembly, because you will be opening that housing on a fixed schedule for the life of the unit.
Confirm the power source the spec calls for, and whether it needs its own circuit or a specific outlet type. Ask who is responsible for bringing power to that point if it is not already there.
Lamp, sleeve, and indicator
The lamp sits inside a quartz sleeve, and the sleeve needs to stay clean for the light to reach the water. Ask the installer how to tell a fouled sleeve from a failing lamp, and what the manufacturer says about cleaning the sleeve. Ask what the status light or alarm means in each state, and what the unit does if the lamp fails or power drops. A unit that shuts off is safer than one that keeps running dark, but you need to know which one you have.
Record the lamp's installation date and its rated life on the unit or in your log. Ask whether the manufacturer offers a replacement reminder, and whether the replacement lamp is a standard part or proprietary.
First run and handover
On the first run, watch for leaks at every fitting, confirm the indicator reads as the manual says it should, and check that water is flowing at the faucets you expect. Ask the installer to walk through the shutoff, the bypass, and the drain or flush steps, and to show you the lamp and sleeve access points with the housing closed.
Before the installer leaves, get the model number, serial number, lamp part number, and the replacement date written down. Keep the spec sheet and warranty with the install paperwork. If anything in the handover is unclear, ask for it again in writing before you sign off. A clear handover is the cheapest part of the whole process to get right.