Most replacement quotes are written around the new unit. The old one gets a line or nothing at all, and that is where surprises start. Before install day, you need to know who owns the old equipment, who shuts it down, who disconnects it, who hauls it away, and what is left in the plumbing when the crew leaves.

Find out who owns the old unit

Look at the data plate on the old unit and at your paperwork. If you bought it, it is yours to dispose of. If it was leased or rented from a provider, the agreement will say whether the provider picks it up, when, and what happens if it is not returned. Ask the provider directly before install day and get the pickup arrangement in writing, so the new installer is not left waiting on a machine nobody is coming to collect.

Assign each removal step on the quote

Read the scope for the words remove, disconnect, cap, haul, and dispose. If they are missing, ask. Get the installer to confirm in writing who closes the old unit's supply valve, who disconnects power if the old unit is electric, who drains the tank, who disconnects the drain line, and who takes the old unit out of the building. A step that is missing from the quote usually turns into an extra charge on install day, or a job left half done.

Handle the rinse water, salt, and spent media

A softener brine tank holds salt and water that has to be emptied and rinsed. A filter tank holds spent media. Ask how the installer handles the old media and the rinse water, and whether they dispose of it or expect you to. Disposal rules for spent media vary by location, so check what your local waste service accepts before you agree to anything. Do not assume the drain you are using for the new unit can take the old unit's rinse water all at once.

Look at the stubs left in the wall

When the old unit comes out, the pipe stubs stay behind. A careful installer caps or plugs them and checks the caps before leaving. Ask where each stub will be, whether it will have a shutoff, and whether every connection will be sealed and tested before the crew packs up. A capped line with no shutoff, or a joint that weeps slowly, is a problem that shows up after the crew is gone. Ask for photos of the finished connections and keep them with the install paperwork.

Check the path before the crew arrives

Old tanks are heavy and awkward to move. Measure the route from the unit to the outside door or the truck, including doorways, stairs, basement corners, and any tight turns. Ask whether the installer carries the old unit out or whether the homeowner has to clear the way. If the old unit is large, ask whether the crew has the equipment to move it safely or needs a second person. Clear the path before the crew arrives so nothing gets blocked during the walk out.

Record what left the building

Write down the old unit's make, model, and serial number, along with a removal note stating who took it away. If the old unit was on a service account, make sure that account is closed or moved to the new unit, so you are not billed for equipment that no longer exists. Keep this record with the new unit's install papers. When a future technician asks what was there before, you will have the answer ready.

Walk the space before you sign off

Once the crew is gone, walk the space again. Look at the floor under and around where the old unit sat, and check for staining, moisture, or soft spots. Check the capped lines once more. Confirm that the new unit is the only unit on the line and that the valve and bypass settings match what the installer left. If something is wrong, say so before the final payment goes out, not after.