Most homes have one main line coming in, but not every tap on that line needs the same water. The kitchen cold tap, the shower and the washing machine are the fixtures people usually care about for taste, scale and skin. The garden hose bib, the irrigation zone and an outdoor wash station are a different group. Before you size anything, decide which of those points get treated water and which stay as they come in. That decision sets the flow you have to design for, and it changes what you pay for.

Walk the house and list every outlet

Start with a written list, not memory. Go room by room and note each indoor tap, shower, toilet fill, washer, dishwasher, water heater feed and ice maker if there is one. Then go outside and note every hose bib, any irrigation valve, a pool or hot tub fill if you have one, and any outdoor shower. Check the basement or utility room too, since a laundry sink or a second hose bib may sit on a different branch than the kitchen. Mark which outlets you use every day and which only run a few times a season.

Find where the outdoor lines branch

Look for the point where the outdoor line leaves the main. In some homes it leaves before the spot where a whole-house unit would sit, so a unit placed on the main sends treated water to the garden by default. In others the branch comes off after the main shutoff, and the outdoor line can be separated more easily. Trace it with the homeowner's plumbing map or with the installer. Then ask one plain question: at the spot where you propose to put the equipment, does the outdoor line draw water before or after treatment, and can that branch be isolated with its own valve?

Decide what the garden should get

Plants and lawns have their own water needs, and softened water is often a poor fit for them. A sediment or chlorine filter may be a different story, so the answer depends on what the equipment does. Decide the purpose of each outdoor point before you pick a design. Your options usually come down to three: leave the outdoor line raw, treat it with a separate small filter, or send it through the main unit and accept what that means for the plants. Write down the choice, because the sizing depends on it.

Size only the flow you are treating

Once you know which points are on the treated side, add up the flow those points can draw at the same time. Leave out the garden hose bib if it sits on a raw branch. Do count the indoor fixtures that could run together, such as a shower with the washer filling plus the kitchen tap. A common mistake is to size for the whole house and then pay for capacity that never gets used. The opposite mistake is to size for a few fixtures and then find the shower pressure drops when the dishwasher starts. Ask the installer to show the flow figure they used and the list of fixtures they counted.

Put the bypass and the valves on the plan

A split design needs a bypass so the unit can be serviced without cutting water to the house, and separate valves so the raw and treated branches can be shut on their own. Ask where each valve sits and who will label them at install. Ask whether the outdoor line has a shutoff you can reach in winter. Ask whether the bypass lets raw water reach the house while the unit is out for service. If the answers are vague, the quote is not ready to compare.

Questions to put in writing before you sign

Ask each provider for a short written answer to the following: which outlets sit on the treated side and which sit on the raw side; what flow figure the sizing uses and which fixtures were counted; where the bypass and each shutoff are located; whether any outdoor point or irrigation zone is included in the treated flow, and why; and who labels the valves at install. Compare the written answers across providers the same way, so the quotes are judged on the same scope. Once the split is settled, the rest of the sizing follows the usual steps, and the numbers will match the house you actually have.