A water softener regenerates by drawing brine from the brine tank, where salt dissolves in water to make the solution the unit uses to recharge its resin. When the salt stops dissolving properly, the softener can keep running its cycle while the resin gets less brine than it needs. The result is hard water that the unit does not seem to notice.
What a salt bridge and salt mush look like
A salt bridge is a hard crust that forms across the tank, leaving an air gap between the salt above and the water below. Salt above the crust stays dry and never dissolves. Salt mush is the opposite problem: a soft, sludgy layer at the bottom that builds up when the salt is of poor quality or the tank has been left to sit. Both need attention, and both are easy to miss if you only look at the lid.
Check the salt level and the salt type
Open the brine tank lid and look at the salt level. Keep the salt high enough that the water level sits where the owner's manual says it should, and do not fill past the fill line the manufacturer marks. Use the type of salt the manual recommends, whether that is pellet, crystal or another form. Different salts behave differently in the tank, so switching types without checking is a common source of bridging.
Break up a bridge carefully
If you see a crust, follow the manual's method for breaking it up. Many owners use a wooden or plastic handle to gently push on the crust until it breaks, without striking the tank walls or the float. Avoid sharp metal tools, which can scratch or damage the tank and any safety float. Do not stand over the tank with your face close to the opening while you work. Once the bridge is broken, check that the salt dissolves and the water level returns to normal.
Clean out mush and check the float
If there is sludge at the bottom, remove it using the method in the manual. A wet vacuum made for this kind of work is a common choice. While the lid is open, check that the float moves freely and is not caught on salt or debris. A stuck float can keep the unit from drawing brine correctly even when the salt looks fine.
Keep the paperwork with the unit
Keep the owner's manual where you can find it, note the salt type you use and when you last checked the tank, and know who holds any service agreement for the softener. If the same problem comes back, that record helps whoever looks at the unit next. For help finding a qualified provider in your area, the Midwest Water Ratings regional index lists providers across Midwest metros.
When to call a technician
Call a technician if bridging keeps returning quickly, if the water stays hard after a regeneration cycle, if the tank or float is cracked or damaged, or if the control shows an error code you cannot resolve with the manual. Those are signs of a problem beyond routine salt care, and the person doing the repair should hear about the bridging history before they start.