Water treatment equipment is often sized by how much water you use in a day, but a home with a tankless water heater has a different problem. The unit has to keep up with the peak draw, the moment when two or three fixtures run together, and it has to do so without starving the heater. This guide walks through the flow check that most sizing conversations skip.

List the fixtures that draw water

Write down every fixture that could run at the same time: showers, kitchen and bathroom faucets, the washing machine, the dishwasher, and any outdoor hose bib. For each one, find the flow rating printed on the fixture or in the manual. Do not estimate from memory. The rating is what the fixture pulls when fully open at normal house pressure.

Pick the worst-case group

Circle the group of two or three fixtures that most often run together in your home. A morning shower with the washing machine filling is a common example. Add their flow ratings to get the peak draw. This is the number the treatment unit has to deliver without the flow dropping below what the household expects.

Compare against the unit's rated flow

Every treatment unit has a rated flow, and the maker states the pressure drop at which that flow applies. Ask the provider for the flow the unit delivers at your peak draw and at the pressure you actually have, not only the nameplate maximum. If the rated flow at the stated pressure drop sits below your peak draw, the unit will feel weak whenever the peak occurs.

Check the heater's minimum flow

Many tankless heaters need a minimum flow before they fire. Find that figure in the heater's manual. A treatment unit can lower the pressure on the heater's supply, which can push a low-flow draw below the heater's threshold and leave you with cold water at a single tap. Ask the installer to confirm that the heater's minimum flow is met at your lowest typical draw, such as a single faucet at low flow.

Measure your house pressure

Low house pressure makes every flow number worse. Attach a pressure gauge to an outdoor hose bib while the house is in normal use and note the reading. Ask the provider whether they measured pressure or assumed it, and whether the unit's pressure drop was included in the flow calculation.

Confirm the connection size

A unit can be rated for enough flow but still choke at a small pipe connection. Ask what pipe size the unit connects to, what size the existing supply line is, and whether any adapter or larger fitting is needed. Ask for this in writing with the flow figure, so the sizing and the install match.

Ask about a bypass for service

Ask whether the installation includes a bypass valve so the house keeps water while the unit is serviced. A bypass also lets you compare flow with the unit in and out, which is a simple way to check whether the unit is the cause of a weak tap.