A sediment pre-filter is the first piece of equipment many well owners add, and it is often sized by guesswork. The cartridge does not know how hard your pump works. The pump, the pressure tank and the number of fixtures open at once decide how much water has to pass through the housing each minute. That flow figure is what you match before you buy anything.
Start with the pump and the pressure settings
Find the rating plate on the well pump, or ask the contractor who installed it for the rated output. Also write down the pressure switch settings: the pressure at which the pump starts and the pressure at which it stops. Keep these three numbers together in one note. They describe the work the filter will do every time the pump runs.
A housing rated below what the pump can push will restrict flow whenever the pump runs hard. You usually notice this at the shower or the washing machine before you notice it anywhere else, as a weak stream that drops off during a second draw.
Check the housing rating against the peak, not the average
Ask the supplier for the rated flow at a stated pressure drop, not just the maximum flow printed on the box. Then compare that rating with the pump output you wrote down. If the housing rating is close to the pump output, expect some loss of pressure at the taps when two or three fixtures run together. If you have a large gap, the filter is probably fine for daily use but may still limit a heavy morning.
Confirm the port size on the housing against the pipe already in the wall. A reducing fitting can add restriction that the cartridge rating does not show, so check the fittings as part of the flow number, not as an afterthought.
Check the position in the system
Confirm whether the filter sits before or after the pressure tank and the pressure switch. Installers place it differently for good reasons, and the wrong location can change the pressure the pump sees. Ask the installer to show you where the tank tee and the gauge sit, and write the answer on the housing bracket or in your home file.
Questions to put to the installer or supplier
- What is the rated flow at the pressure I gave you, and where is that figure printed?
- What micron rating are you using for sediment, and why that one for my water?
- Does the housing sit before or after the pressure tank, and what changes if I move it later?
- How will I know the cartridge is loading up, and what pressure drop counts as a signal to change it?
- If I add a second fixture or a larger bath later, does the housing still fit my pump output?
If the answers are vague, ask a licensed well contractor to check the pump output and pressure settings before you buy. The sizing job is simple once the numbers are on paper.