A treatment filter rarely fails with a bang. The usual sign is that water still runs, but a little less of it reaches each tap, and the change is so gradual that people adjust without noticing. By the time the shower feels weak to everyone in the house, the cartridge has often been restricting flow for a long time. This guide covers how to catch that early, what to check yourself before calling anyone, and what to ask a provider when you do.

What a clogged filter does to your flow

A sediment filter or whole-home cartridge housing slows water on purpose. It catches particles, and as they build up on the cartridge, resistance across the housing rises. Water still gets through, so the system looks normal, but the pressure on the outlet side is lower than on the inlet side. That difference is called pressure drop. Every filter has a maximum pressure drop it is designed to handle. The manufacturer's documentation, or the label on the housing, is where to find that limit.

Early signs to watch for

Look for these before the problem becomes obvious. A shower that is softer than it was when the system was new, especially at the hot tap, is the most common first clue. Washing machine or dishwasher fill times that have stretched, without any change in how you use them, are another. A faucet aerator can look clean and still give a weak stream if the restriction is upstream. On a well system, a pump that starts more often than it used to can mean the pressure switch is seeing demand it has trouble meeting.

The reverse symptom matters too. If a filter was serviced and a bypass valve was left in the bypass position, you get full pressure but untreated water. Strong flow does not prove the filter is working, so do not treat it as a clean bill of health.

Check before you call

Start with the gauges. If the housing has a gauge on the inlet side and one on the outlet side, read both with water running. The gap between them is your pressure drop. Compare that gap to the maximum in the documentation. If there are no gauges, compare flow at the same tap, at a similar time of day, using the same fixture. A bucket and a timed fill is a rough test, but it is honest and repeatable, and it gives you a baseline to compare against later.

Next, find out whether the problem is the whole house or one fixture. Weak flow at a single tap points to that fixture, not the filter. Then check the valves. Confirm the inlet and outlet valves are open and the bypass is in service position. Do not force a stiff valve. Note it and tell the provider.

Check the cartridge history. Find out when it was last changed. If you keep a log, look there. If you do not know, that gap is itself a finding, and it is worth starting a record now. Finally, if you have a hose bib on the supply side of the housing, test flow there. If that is weak too, the cause sits upstream, in the municipal supply, the well pump, or the pressure tank, not in the filter.

What to ask the service provider

Ask them to read the pressure on both sides of the housing and tell you the difference, not just whether the water flows. Ask which cartridge type and micron rating they installed, and whether it matches the original specification on the housing. Ask whether they checked the bypass and valve positions before leaving.

Ask what they will check next if pressure drop is still high after the change. That way you know the next step before you pay for a second visit. Ask whether their replacement schedule is tied to the manufacturer's stated cartridge life or to your actual water use, and what would make them change it sooner. Finally, ask what they will write down and leave with you, so the next visit starts from your readings rather than from memory.

When it is probably not the cartridge

A sudden drop in flow, rather than a gradual one, usually points away from clogging. Check whether a valve was moved, whether a new fixture or leak has started, or whether the supply itself changed. On a well system, a sudden drop can also mean the pump, pressure switch, or tank needs attention. That is a question for a qualified well technician, not a cartridge swap.

If you decide to hire someone, it helps to know how providers are compared before you choose. See How We Rate Water Treatment Providers for the criteria behind the ratings on this site.