Once the crew packs up, the equipment is the only record of what was done. Hidden connections, valve positions and factory settings are easy to forget and hard to reconstruct later, especially when a different technician is called in for a service visit. A short set of photos taken during the job takes a few minutes and saves a lot of guessing.

Photograph the connections before anything is covered

Take clear photos of every pipe connection to the unit, both inlet and outlet, along with the bypass valve. Include one wide shot that shows where the unit sits relative to the main shutoff, so someone can find the water line without asking you. If pipe runs into a wall, floor or ceiling chase, photograph it before the cover goes back on. If the installer tells you the pipe material, write it in the photo caption.

Record the valve positions as they are set on install day

Ask the installer to confirm which position each valve is in during normal operation and which position means bypass. Photograph the handles or dials in each state, and write the position in plain words beside the photo, using whatever labels the unit itself shows. A valve left in the wrong position is an easy way to make a working unit look broken, and a clear record makes that quick to rule out.

Capture the model details and the programmed settings

Photograph the label showing the model number and serial number, and photograph the control display showing the settings at startup. For any unit with adjustable settings, write down what the installer set and the value of each setting, then ask them to confirm it in writing. If a pressure reading was taken at startup, keep it, and note the conditions it was taken under, such as which taps were open and whether the unit was running.

Store the set where you can find it

Put the photos, the model details and the written settings in one folder, paper or digital, and keep a copy with the warranty paperwork. Name the files plainly, such as inlet connection, bypass valve position or control settings, so anyone can use them without asking you what they mean. If you change providers later, this folder lets the next person start without tracing every line again.

What to ask the installer before they leave

Ask them to walk through the photos with you and point out anything they would want the next technician to check first. Ask whether they will give you a copy of the final settings in writing. If they are unwilling to share those details, that is worth raising before you sign off on the job, because the same gap will show up at the next service visit.