A well pressure tank stores water under pressure so the pump does not have to run every time a faucet opens. Inside, a cushion of air pushes against the water. When that cushion shrinks, the tank holds less usable water, and the pump starts and stops far more often than it should. Knowing what the tank does and how to check it helps you catch a problem before it shortens the life of the pump.

Signs the tank needs attention

Watch for the pump turning on and off in quick bursts even when only one faucet is running. Pressure that swings sharply at the tap, or faucets that sputter and spit when first opened, can point to a tank that is waterlogged or short on air. These signs do not prove the cause, but they are reasons to check the tank before assuming the pump is failing.

Work with the power off

Before you touch the tank, turn off power to the pump at the breaker and close the valve that feeds the tank. Make sure you know whether your tank has a replaceable bladder or a fixed diaphragm, because the procedure and the repair route differ. If you are not sure which type you have, check the label on the tank or the manual.

Check the air charge

With the pump off and the tank drained, use a tire-type gauge on the air valve at the top of the tank. Compare the reading with the number on the tank label or in the manufacturer's guidance. The target is usually set a little below the pump's cut-in pressure, which is the pressure at which the pump starts. If the reading is low, add air using the valve, then restore power and watch the system cycle normally.

Check the pressure switch

The pressure switch controls when the pump starts and stops. If the tank charge is correct but the pump still cycles quickly, the switch settings or contacts may need attention. Adjusting or replacing a switch involves live electrical parts, so this is the point to call a licensed well contractor unless you are trained to do it safely.

Keep ownership records

Know who owns the pump system: you, a previous owner, a water provider, or a service company under contract. Keep the manuals, the tank model number, the date of the last air check, and any warranty papers together with the house records. When a repair is needed, these records tell a technician what is installed and what has already been done, which saves time and reduces guesswork.

When to call a professional

Call a licensed contractor if the tank will not hold air, if you see water at the air valve, or if the pump runs continuously. Those signs point to a failed bladder or a larger problem in the well system, and they need a qualified diagnosis before anyone replaces parts.