If you rent, the water treatment question has two parts that a homeowner does not face: what the equipment will connect to, and who gets to decide whether it goes in at all. Settle both before you compare models. A unit that fits the space on paper may not be allowed there, and a unit that is allowed may leave a plumbing change behind when you move out.
Start With the Lease and the Landlord
Read the lease for any clause on alterations, fixtures, or changes to plumbing and electrical. Then ask the landlord in writing what you propose to install, where it would connect, and whether it can be removed at the end of your tenancy. A written yes that names the location is worth far more than a verbal okay. If the answer is no, your choices narrow to equipment that does not touch the plumbing, such as a countertop unit or a faucet-mounted filter. That choice changes the sizing question too, because those units are judged by drinking water volume rather than whole-house flow.
Map What You Would Be Connecting To
Before you shop, photograph and note the cold supply line where any whole-house equipment would tie in, the existing shutoff valves, any filter or softener the landlord already owns, the water heater connection, and the nearest drain. Write down the pipe material and size, and whether a bypass already exists. A system that needs a new shutoff, a new drain point, or a bypass the house does not have is a larger change than the unit itself, and it is the change most likely to be refused. If the equipment regenerates or discharges water, confirm which drain it would use and whether that drain is accessible for a hose or standpipe without modifying the wall or floor.
Check Space, Power, and Access
Measure the floor area, the height under any shelf or sink, and the clearance needed to change a cartridge or add salt. Check whether a power outlet is within reach if the unit needs one, and whether the floor in a basement or utility closet can take the weight of a full tank. Confirm you can reach the unit for service without moving the landlord's stored items, the washer, or the water heater. The things most often missed are the door swing, the sightline to any gauge or indicator, and the stop valve, which must stay reachable in an emergency.
Decide the Exit Before You Enter
Ask what happens when you leave, and get the answer in writing. Settle who removes the equipment, who pays for that removal, who restores the original fittings, and whether any patch or repair falls to you. Keep the original fittings, caps, and nipples in a labeled bag so restoring the plumbing is a short job rather than a search. If the landlord wants the equipment to stay, agree on the terms for that as well, including what happens to the unit's warranty and service contract when the tenancy ends.
Compare Options by What They Leave Behind
Compare the candidate types on what each one leaves in the home. A plumbed-in whole-house unit leaves the most change. An under-sink or inline unit leaves a smaller footprint. A pitcher or faucet attachment leaves nothing behind except its cartridges, and its sizing question becomes how much drinking water you use and whether the cartridge rating matches what you want removed. For each option, ask the seller or installer what is connected, what must be cut, what can be reversed in an afternoon, and whether the service terms still hold if the unit is moved. For a broader view of how providers are evaluated, see How We Rate Water Treatment Providers.
Settle the Service Route in Writing
Decide who calls for service, who pays for a repair, and who makes the call when a unit leaks. Put that answer in the same written note as the landlord approval, so the three questions of permission, plumbing, and exit are settled together. Ask the provider whether they will work in a rented home, whether they will take a call from the tenant, and whether they will coordinate with the landlord when a repair needs access to shared plumbing.