A duplex, or any home split into two units with separate kitchens and bathrooms, changes the sizing question. Most product listings assume one household. In a split home, two households share the same service line, the same meter, and often the same main shutoff. The unit you choose has to handle the sum of both sets of fixtures at the same time, not just the bigger side.

Start with the shared line

Before you look at any equipment, find out where the line splits. Ask the owner or check the plumbing for the point where both units are fed. If a whole-house unit goes on the main before the split, it treats both units as one load. If each unit has its own branch, you may be sizing two separate points, and one larger unit may be the wrong choice. Confirm which pipe the equipment will sit on and its size.

Count the fixtures that can run at once

Write down every tap, shower, toilet, dishwasher, washing machine, and outdoor hose bib on both sides. Mark the ones that are often used together, such as two showers and a washer running on the same morning. That peak is what the equipment has to keep up with. Compare it to the flow rating on the product sheet, which is usually stated in gallons per minute at a given pressure. If the sheet does not give a rating at a flow you can reach, ask the seller for it in writing before you buy.

Decide whether one unit or two is the answer

There are two sensible setups. One is a single whole-house unit on the main, which keeps service in one place and gives both households the same water. The other is a separate unit for each side, which lets each household handle its own cartridge changes and keeps one unit's heavy use from affecting the other. Neither is automatically better. Choose based on who pays, who services the equipment, and whether the two households have similar water needs. If one side is a rental, get in writing who changes cartridges and who calls for repairs before install day.

Check the space and the access

In many duplexes both units share one mechanical space, so measure the footprint, the clearance above the housing for cartridge removal, and the drain or bypass access. Confirm that a cartridge can be changed without cutting water to the other unit for longer than needed. Ask the installer to show where the bypass valve is and to label it.

Questions to ask before you sign

Ask the seller or installer which fixtures they counted when they sized the unit, and whether they counted both units. Ask what flow the unit delivers at the pressure your home actually runs, not only the maximum on the box. Ask who orders replacement cartridges and who does the swap. Get the answers in writing along with the model number, so the quote matches the equipment you are actually getting.

For the general method behind comparing providers, see How We Rate Water Treatment Providers. For the regional overview, see the Midwest Water Ratings index.