Activated carbon removes many taste, odor and chlorine compounds by holding them on its surface. Once that surface fills up, the filter stops holding them and they pass through. This is called breakthrough, and it usually shows up gradually. The earlier you catch it, the less time you spend drinking water that no longer tastes like what the filter was meant to deliver.
The taste comes back first
The first sign is usually a return of the chlorine or chemical taste or smell you had before the filter was installed. It may show up only in the first glass after the water sits, or only in hot water if the filter is on a line that feeds hot water. Taste is a useful early signal, but it is also subjective and can change with the time of day, so keep notes rather than relying on memory. Write down the date you last changed the cartridge, the approximate time you first noticed the taste, and whether it appeared in cold water, hot water, or both.
Watch the flow and the housing
A slowing flow can mean sediment is building up in a pre-filter or in the carbon itself. A slow fill of a kettle or a weaker stream at the tap is worth checking against your usual pattern. Look at the housing for water beading or drips, and check the O-ring seal each time you open it. If the housing shows signs of leaks, do not wait for taste to tell you something is wrong. Turn off the feed and contact the installer or manufacturer for a check.
Compare the change interval to your own use
Cartridges are rated in gallons, months, or both, and the rating assumes a particular water quality and daily draw. A household that uses far more water than the rating assumes will reach the limit sooner. Ask the provider for the rated capacity in gallons and the time limit in months, then estimate your household use from your water bill or meter reading. Use whichever limit comes first as your change date.
Write that date on the housing or in a note on the fridge. Changing on schedule is cheaper than waiting for breakthrough and finding out the water has been unfiltered for weeks.
What to ask the installer before the first change
Ask which cartridge model belongs in the housing and where to buy the exact replacement. Ask what the taste or flow looks like when the cartridge is spent, so you know whether the signs above match. Ask whether a long unused period, such as a vacation, changes the change schedule. Get the answers in writing.
If you want a sense of which providers publish clear change intervals before you buy, the regional index is a starting point: Midwest Water Ratings: The Regional Index of Home Water Treatment Providers.