Most owners book a yearly service visit as the annual and assume it covers everything. Later they find out the tech checked the unit but did not replace the parts that wear, or that a part they expected was a separate charge. The fix is simple: know the scope before the appointment, not after the invoice arrives.
Ask for the list before you book
Ask the provider for the written inspection and service list for your model. Ask whether every visit follows the same list or whether it is adjusted for your equipment. Then sort the list into three groups:
Items replaced on every visit, such as seals, O-rings or media if your unit uses them on a schedule. Items inspected only, where the tech looks, reports and leaves the part alone. Items priced separately, where the tech finds a problem and must quote before any work starts.
If the provider cannot show you this list in writing, treat that as information about how the visit will go. Keep the list with your equipment records so the next visit can be compared against it.
What the visit should check
Ask the tech to check each of these and to note the result, not just to say the unit is fine:
Control valve: that it moves through each stage of its cycle without stalling, and that the timing matches what was set.
Brine system: the brine line, the brine valve and the float, to confirm they move freely and do not leak. Your own salt level checks are a separate job, so this is only the mechanical look.
Bypass valve: that it moves cleanly, and that the home returns to treated water once it is set back to service. Ask the tech to run the water at a tap afterward.
Drain connection: that the drain line is secure, not kinked, and that the connection meets the setup the installer described.
Fittings: a look for drips or residue at every joint, with the location written down if anything is found.
Settings: the hardness setting, the regeneration schedule and the capacity as found on arrival, compared against how your household uses water now. A household that has changed in size or habits may need different settings, and the tech should say so in writing rather than quietly changing them.
Pressure at the treated line, recorded before and after the visit.
Make the paper match the visit
After the visit, you should have a written record with the date, the model and serial number, what was done, any parts replaced with their part numbers, the settings found and the settings left. Keep a copy with your other equipment papers. The record is the only way to tell next year whether something changed between visits or was never checked.
If anything was found but not fixed, ask for it to be written as a finding with a quote, and set a date for when you will decide. Do not let a verbal note turn into an assumption.
What to compare between providers
When you compare who does the visit, lay the scope lists side by side rather than the headline price. Look at whether the visit fee includes parts, whether findings are quoted before parts are ordered, and whether the provider will send your service history to you if you change companies. A low visit fee with every replacement billed separately can cost more over a year than a higher visit that covers the common parts.
If you are still choosing a provider, the regional index of home water treatment providers is a starting point for the shortlist, and you can ask each one for its scope list before you decide.
Your question for the next visit
Before the next appointment, ask one question in writing: which items on this visit will be replaced, which will only be inspected, and which will need a quote first. The answer tells you what you are paying for, and it gives you the list to check against when the tech leaves.